Brocade Communications Systems X6-4, Hardware Installation Manual, Page: 48 / 249

5. Secure the device to the rack with six 10-32 screws with washers. Tighten the screws according to specifications under Torque
requirements on page 42.
NOTE
Screws, clip nuts, and retainer nuts to secure the device to the rack are provided in the device hardware accessory kit.
FIGURE 15 Device and 27-31 in. (68.58 to 78.74 cm) kit installed in rack
1. Screw locations for 10-32 x .5 in. (1.27 cm) Phillips screw
with blue Loctite on threads or 10-32 x .63 in.(1.60 cm)
Phillips screw with square cone washer for racks that have rails with round holes. Use either 10-32 retainer nut for racks that
have rails with square holes or 10-32 clip nut for racks that
have rails with round holes to retain screws.
NOTE
For rails with round holes, use the clip nuts (refer to Figure 10 on page 42) on the rails for securing the 10-32 screws.
For rails with square holes, use the retainer nuts (see Figure 10 on page 42). Also refer to Figure 11 on page 43.
6. Reinstall the device door. Refer to procedures for removing and replacing the device door in this guide.
Installing the 8U Chassis Airflow Diversion or Port Side Exhaust Kit for Four-Post Racks (XBR-DCX4S-0121 and XBR-DCX4S-0130)
Brocade X6-4 Director Hardware Installation Guide
48 53-1004106-07