Brocade Communications Systems X6-4, Hardware Installation Manual, Page: 32 / 249

• Hardware devices illustrated in these procedures are only for reference and may not depict the device you are installing into the
rack.
Time and items required
Allow approximately one hour to unpack and install the device in a rack.
The following tools are required when installing the 8U Airflow Diversion and Port Side Exhaust Kit for Four-Post Racks (XBR-
DCX4S-0121 and XBR-DCX-0130):
• Torque wrench with #2 Phillips screwdriver tip
• Flathead screwdriver
• Hydraulic or assisted lift with a minimum raise of 140 cm (55 in.) and a minimum capacity of 113 kg (250 lbs).
Installing the device in an 18–24-inch rack (XBR-DCX4S-0130)
Use the following instructions to install the device in a rack with rail-to-rail depth of 18 to 24 in.(45.72 to 60.96 cm). Be sure to use the
18–24 in.
8U Chassis Airflow Diversion and Port Side Exhaust Kit for Four-Post Racks (XBR-DCX4S-0130) for this installation.
Parts list
The following parts list refers to items illustrated in the following figure.
NOTE
Not all parts may be used with certain installations depending on the device type.
TABLE 7 Hardware for Airflow Diversion and Port-Side Exhaust Kit for 18-24 in. (45.72 to 60.96 cm) racks
Description Quantity
Top rail 1
Top rail mounting brackets for 18-20 in., (45.72-50.8 cm) 20-22-in. (50.8-55.88 cm), and 22-24.in (55.88-60.96
cm) racks 3
Duct 1
Shelf 1
Shelf saddle 1
10-32 x .5 in. (1.27 cm) Phillips screw (blue Loctite on threads) 12
10-32 x .63 in.(1.60 cm) Phillips screw with square-cone washer 12
10-32 clip nut for racks that have rails with round holes 8
10-32 retainer nut for racks that have rails with square holes 8
Alignment washer for racks that have rails with square holes 12
6-32 x .25 in. (.635 cm) Phillips screw 2
Installing the 8U Chassis Airflow Diversion or Port Side Exhaust Kit for Four-Post Racks (XBR-DCX4S-0121 and XBR-DCX4S-0130)
Brocade X6-4 Director Hardware Installation Guide
32 53-1004106-07