23
AQM - Agile QAM Modulator
Interleaver
The Convolutional Interleaver is user selectable. Various choices
are available depending on the Operation Mode.The standard
settings are as follows:
ITU-A - I 12, J17
ITU-B - I 128, J1
Baud Rate
The Baud Rate needs to be programmed based on the Input Data
and QAM Mode used. The range is from 1 to 6.9 MBaud.
Input
The AQM Input Signal is fed to the module via the BNC connector
on the rear panel. ASI (Asynchronous Serial Interface) data is
typically used. The unit is also programmed with the ability to
generate a PRBS (Pseudo Random Binary Sequence) test signal.
The PRBS signal is a polynomial sequence that is determined by
the Input Selection choice. The following settings are available.
PRBS 25M
PRBS 23
PRBS 15M
PRBS 15
These selections are also valuable if an Input ASI signal is not
available. This can be helpful in balancing the Output Level of
several units without the need for an Input ASI signal.
Summary of Contents for AMM-806
