CHAPTER 7: Operation
61
8-11. Link 0, Link 1, Link 2, and Link 3 Station Addresses
Valid values are: 0 through FE Hex. If 0 is entered, the LinkUp 5294 assumes that the Link Station
Address is not to be used; if a Hex value beginning with an alpha character (A through F) is entered,
that Hex value must be entered with a leading 0 in this example: 0A9.
Link Station Address is the term used to identify one of the LinkUp 5294 emulated controllers. To
establish a communication link with your 3X host, you must define a viable Controller Address from the
host for each controller.
NOTE
On deluxe models only, more than one Link Station Address can be supported for each
synchronous port. This enables the LinkUp 5294 to emulate as many as four IBM
Remote Controllers on a single port from a single line ICA.
CAUTION
If your unit is a deluxe model, note that each synchronous port configured to support
two Link Station Addresses must have two distinct Controller Addresses, and must use
the same emulation mode (5251, 5294, or 5394).
NOTE
If more Station Addresses are specified in Parameters 8 through 11 than were specified
in Parameter 7, the following error message is displayed:
n: INCOMPATIBLE WITH PARAMETER 7.
7.5.7 A
SYNCHRONOUS
P
ORT
P
ARAMETERS
The Asynchronous Port Menu is shown below:
1. Device Type
Valid values are:
Current Parameter Values For Port 4 (ASYNC):
1. Device Type
ADM3A+
2. Associated Logical Unit
4+
3. Communications Interface
DCE
4. Bit Rate
AUTO
5. Number of Bits/Char (Excluding Parity)
8
6. Parity
NONE
7. Number of Stop Bits
1
8. Connect Mode
DED
9. Flow Control from Converter
XON
10. Flow Control from Device
XON
11. Device Ready Signal
DTR
12. Packet Network Access
N
13. Auto Exit Enabled
YES
Enter Change(s):
