BeneVision TM80, Operator'S Manual

Page: 167 / 240

BeneVision TM80 Telemetry Monitor Operator’s Manual 14 - 1
14
Battery
14.1 Introduction
The telemetry monitor can be powered by a lithium-ion rechargeable battery pack or AA
batteries. This chapter provides instructions on how to use, maintain, and dispose of the
batteries.
14.2 Safety
WARNING
•
Keep the batteries out of children’s reach.
•
Keep the batteries in their original package until you are ready to use them.
•
Make sure to install the lithium-ion battery pack or the AA battery tray and
close the battery compartment during defibrillation.
•
Only use recommended AA batteries or rechargeable lithium-ion battery to
power the telemetry monitor. Other power supply may cause damage to the
equipment or lead to body injury.
•
While installing AA batteries, do not apply reverse polarity.
•
Only use recommended fresh AA batteries. Using other AA batteries can give
unacceptable performance.
•
Do not mix batteries of different charge/voltage levels.
•
Do not mix batteries of different chemistries.
•
Only use specified rechargeable lithium-ion battery. Unspecified lithium-ion
battery can give unacceptable performance.
•
If a battery shows signs of damage or signs of leakage, replace it immediately.
Use caution in removing the battery. Avoid contact with skin. Refer to qualified
service personnel.
•
Some failure conditions, such as short circuits, can cause a battery to overheat
during using. High temperature can cause burns to the patient or user. If the
device becomes too hot to the touch, remove it from the patient and place aside
until it cools. Then remove the battery from the device, and contact your service
personnel to identify the cause of overheating.
•
Replace the battery mmediately once the “Critically Low Battery” alarm
message displays. Replace the battery in time once the “Low Battery” alarm
message displays. If those conditions are not corrected, device shutdown and