BeneVision TM80, Operator'S Manual

Page: 132 / 240

11 - 4 BeneVision TM80 Telemetry Monitor Operator’s Manual
11.2.4 Changing the Resolution of Trend Data
1. Enter the tabular trends review page.
2. Tap Interval in the lower left corner of the review page.
3. Tap Interval .
4. Select the desired option.
◆
5 s or 30 s : select to view up to 4 hours of tabular trends at an interval of 5
seconds or 30 seconds.
◆
1 min , 5 min , 10 min , 15 min , 30 min , 1 h , 2 h , 3 h : select to view up to 48
hours of tabular trends at selected interval.
◆
NIBP : select to view the tabular trends when NIBP measurements are acquired.
11.3 Events Review Page
The telemetry monitor stores events in real time, including the “MPAN Disconnected”
technical alarm event, the “SpO
2
No Sensor” technical alarm event, physiological alarm
events, manual events, and operational events.
NOTE
•
A total loss of power has no impact on the events stored.
•
Alarms are saved as events and will be maintained if the equipment is powered
down. The time of equipment power down is not recorded as an event and
cannot be reviewed.
•
Earlier events will be overwritten by later ones if the capacity is reached.
•
When the telemetry monitor is connected to the CMS, if events of the telemetry
monitor are deleted from the CMS, they will not be deleted from the telemetry
monitor and vice versa.
11.3.1 Entering the Events Review Page
Enter the events review page in either of the following ways.
Option 1:
1. Press the key to enter the main menu.
2. Tap Review .
3. Tap Events .
Option 2:
Tap the Events button in the upper right corner of the tabular trends review page.