BeneVision TM80, Operator'S Manual

Page: 63 / 240

BeneVision TM80 Telemetry Monitor Operator’s Manual 6 - 7
■
For technical alarms, alarm sounds are paused, but alarm lamps and alarm messages
continue to be presented.
■
The remaining alarm pause time is displayed in the prompt message area.
■
The alarm pause symbol is displayed in the upper right corner of the main
screen.
The alarm pause time is two minutes by default. You can change the alarm pause time at
the CMS. For details, refer to
BeneVision Central Monitoring System Operator’s Manual .
When the pause time expires, the alarm paused status is automatically deactivated.
NOTE
•
When the telemetry monitor is connected to the CMS and the function of
remotely pausing alarms is enabled at the CMS, alarms can be paused either at
the telemetry monitor or at the CMS. For information on pausing alarms at the
CMS, refer to
BeneVision Central Monitoring System Operator’s Manual .
6.7 Resetting Alarms
You can acknowledge the on-going alarms by resetting alarms. After being reset, the alarm
system can respond to a subsequent alarm condition.
When an alarm occurs, follow this procedure to reset the telemetry monitor’s alarm system.
1. Press the key to enter the main menu.
2. In the Commands section, tap Alarm Reset .
Or
1. Swipe your finger up at the bottom of the main screen to display the quick keys area.
2. Tap Alarm Reset .
NOTE
•
When the telemetry monitor is connected to the CMS and the function of
remotely resetting alarms is enabled at the CMS, alarms can be reset either at
the telemetry monitor or at the CMS. For information on resetting alarms at the
CMS, refer to
BeneVision Central Monitoring System Operator’s Manual .
6.7.1 Resetting Physiological Alarms
After the alarm system is reset, physiological alarms give the following alarm indicators:
■
The alarm sound is silenced.
■
The symbol is displayed in the upper right corner of the main screen.