Benelli Tornado Tre Novicento 903, Workshop Manual, Page: 98 / 336

UK
98
MF9_UK
T T
T T
L I M I T E D E D I T I O N
RECHARGING WITH A VARIABLE TENSION BATTERY CHARGER
Adjust the tension to obtain
the standard recharge
amperage.
Set the time switch on the
basis of the recharge time
determined by the tension at
empty. Refer to “CHECK
BATTERY AND BATTERY
RECHARGE"
If the recharge time requires more tha 5 hours, we advise checking the amperage after 5
hours. If there are variations in the amperage, adjust the tension again to obtain the
standard recharge amperage.
Measuring the
tension at empty
before recharging.
NOTE:
wait over 30 minutes
before measuring the tension at
empty of the battery
Connect the battery
charger and an ampere
meter to the battery.
Begin the recharging
operation.
Is the amperage higher
than the standard
charge indicated on the
battery?
Wait more than 30 minutes before measuring the tension at empty of the battery.
12.8 V = recharge completed
12.0-12.7 V = recharging needs to be carried out
less than 12.0 V = change the battery
NOTE:
Set the recharge tension to 16 ~
17V. (if the tension is lower, the
recharge will be insufficient. If the
tension is higher, the battery will
overload).
Set the recharge
tension at
20~25 V
Check the amperage for 3-5 minu-
tes. Has the standard recharge
amperage been exceeded
If the amperage does not exceed
the standard recharge amperage
after 5 minutes, change the
battery. Refer to “CHECK
BATTERY AND BATTERY
RECHARGE").
Recharge
Ampere meter
YES
NO
YES
NO