Benelli Tornado Tre Novicento 903, Workshop Manual

Page: 81 / 336

UK
81
MF9_UK
T T
T T
L I M I T E D E D I T I O N
The rear brake pads have to be changed when the pad-disk
contact surfaces are coplanar witht the liner (B) present at the
end of the steel casing of the pad.
Apart from a sight check, a particular noise is noticeable during
braking due to the rubbing of the liners on the disk.
The minimum thickness reached by the pad, when the
conditions listed for its substitution are reached, is 3.5 mm.
3.21.1 CHANGE FRONT BRAKE PADS
WARNING:
After changing the brake pads, work on the brake
command with long but not intense braking for
about a hundred Km.
WARNING:
Always change the two pairs of pads together.
Undo the two pins (1) and remove the two springs (2).
Change the two pairs of pads (3).
Re-position the springs (2) and the pins (1).
Do the same for the other front clamp.
3.21.2 CHANGE REAR BRAKE PADS
Remove the safety ring (4), undo the pin (5) on the opposite
side and remove the spring (6).
Change the two pads (7).
Re-position spring (6), pin (5) and secure with ring (4).
WARNING:
After changing the brake pads, work on the brake
command with long but not intense braking for
about a hundred Km.