Beckman Coulter Power Express Aliquot, Instructions For Use Manual

Page: 81 / 122

Aliquotter Error Codes
Aliquotter Error Codes Table 4.4
Sensor Problem Solution
BR01 INI
BR02 INI
BR03 INI
BR11 INI
BR12 INI
BR13 INI
Bar code reader
initialization error.
1. Confirm that the bar code reader cable is connected
correctly.
2. Reboot the module.
3. Place the module in
Run
mode to resume operation.
BUZZ01-0*
BUZZ02-0*
BUZZ03-0*
BUZZ11-0*
BUZZ12-0*
BUZZ13-0*
Line Control CPU Error, bar
code label, or RFID read
error or Sample Positioning
error.
1. Select
Restart
on the control panel to retry.
2. Confirm that the bar code reader or RFID reader reads the
bar code label or RFID tag correctly. If necessary, reprint
the bar code label and re-apply it to the sample tube.
3. If the error persists, select
Clear
on the control panel
to release the carrier. The aliquot process and all sample
tubes in the Aliquot and Labeler components must be
cleared. Refer to the procedure Aliquot and Labeler Lane
Clear.
Drip Cup#1
Drip Cup Tray for Nozzle A
is full.
1. Unlock and open the rear doors.
2. Take biohazard precautions, such as wearing protective
clothing, and remove the drip tray.
3. Empty and clean the tray.
4. Put the tray into place.
5. Close the rear doors.
6. Select
Restart
on the control panel to resume
operation.
Note
If you are unable to access the drip tray, perform
aliquot drip tray error recovery. Refer to Aliquot
Drip Tray Error Recovery .
Troubleshooting
Error Code Tables
4
B31449AE
4-21