Beckman Coulter Power Express Aliquot, Instructions For Use Manual

Page: 46 / 122

Use Bypass only to release empty sample carriers (except as otherwise noted in error
recovery). Samples do not route properly and cannot be reentered or remapped.
1
Select Manual and OK to place the module in Manual mode.
2
Select Maintenance on the control panel.
3
Select Bypass .
4
Wait for all sample tube carriers to pass through the module.
5
Select Enter and select Exit .
6
Select Auto , then select OK to resume processing.
Stop Button Recovery
When you press any yellow or white Stop button (except the Centrifuge Stop button), at any
time during operation, the system disconnects power to the Power Express system. The
Line Control and Cennexus remain
ON . The air system also remains on.
Note
If you press the Centrifuge Stop button, refer to the Centrifuge Stop Button Recovery
Procedure, in the Centrifuge Module IFU, PN B31456 .
Important
Press the Stop button to halt any hazardous condition.
Important
When you press the Stop button, the Line Control cannot accurately represent the
location of the last sample tube sorted by the system.
Caution
If you have an Aliquot module, when you press a Stop button, aliquot tips containing
sample drip very slowly. You may need to clean the drip trays. For more information,
refer to CHAPTER 5, Daily Maintenance Procedures, in the General System Operation
IFU, PN B31448 .
Important
Perform only the Stop button recovery steps that apply to your Power Express
configuration.
Error Recovery Procedures
Power Express Aliquot Error Recovery Procedures
3-6
B31449AE