Beckman Coulter Power Express Aliquot, Instructions For Use Manual

Page: 71 / 122

Labeler Error Codes (Continued) Table 4.3
Sensor Problem Solution
PRNT HEAT
The print head is
overheated.
1. Turn off the power to the unit.
2. Wait for the print head to cool down.
3. Power on the unit.
PRNT OPEN
Unable to send data to the
printer. The printer door is
open.
1. Pull out the labeling component and close the printer door.
2. Press the green feed button to advance the paper so that
the label is positioned correctly inside the printer.
3. Push back the labeling component until the bracket
latches.
4. Reboot the module.
PRNT PAUSE
The printer is paused.
1. Confirm that the printer door is closed and Label Assembly
Drawer is closed. Press Restart .
Note
After opening the printer door to replace the
label roll or clean the print head, press the
green feed button to confirm the label is
positioned correctly inside the printer.
2. If error repeats, press Label Feed button on the Label
Printer. Refer to figure 2.3 and rotate spindle to take up
any loose label paper. Close drawer and press
Restart
.
PRNT STATE
Failed to send data to the
printer.
1. Confirm that the printer is on and the printer data cable is
connected correctly.
2. Reboot the module.
PRNT SYNTX
Syntax error detected in the
data sent to the printer.
Reboot the module.
PS003 PAS
Error occurred while
passing a secondary
container from the tube
delivery belt to the gripper
on the transfer arm.
1. Confirm that a secondary container is not jammed or stuck.
2. Confirm that PS003 works correctly.
3. Confirm that PS003 turns on when there is a sample tube in
front of the sensor.
PS004 PAS
A secondary container does
not drop down the funnel
into a holder on the
rotating table.
1. Confirm that a secondary container is not jammed or stuck.
2. If there is a stuck tube, manually drop the tube down the
funnel to activate PS004.
3. Confirm that PS004 turns on when there is a tube in front
of the sensor.
Troubleshooting
Error Code Tables
4
B31449AE
4-11