Beckman Coulter Power Express Aliquot, Instructions For Use Manual

Page: 33 / 122

Replace the Roll of Labels in the Labeler
Important
The labels for the aliquot tubes are made of special thermal paper. To prevent damage
to the thermal paper, each roll of labels is shipped in a black plastic bag. For best
results:
•
Keep the labels away from heat
•
Keep each roll of labels in its black plastic bag until it is used
•
Use the aliquot labels before the expiration date
Required Materials:
• Roll of Labels (Part Number A16614)
1
Open the Label Assembly drawer. The module automatically goes into Pause mode.
2
To open the printer door, press the flat vertical plate on the left in the direction
indicated on the printer (towards the back).
3
Remove the empty spool or feed through any paper that is left on the label roll.
4
Check the inside of the printer for dust. If necessary, clean the inside of the printer and
the print-head:
a. Remove any excess labels or glue from the printer, roller, or label guide.
b. Clean the print-head and label sensor with cotton-tipped applicators.
Caution
Use only dry cotton-tipped applicators to clean the print-head and label
sensor. Other cleaners can damage the print-head. Sharp objects can damage
the label sensor.
c. Clean the label roller with a moistened soft cloth, soft tissue, or cotton-tipped
applicator. Clean each section with the moistened cloth as you rotate the roller.
Refer to
Figure 2.2 Inside of Label Printer (with door open) .
Power Express Aliquot Module Procedures
Replace the Roll of Labels in the Labeler
2
B31449AE
2-3