Baumuller BM5-O-SAF-002, Operation Manual, Page: 43 / 182

Description of the Safety Module
Operation Manual Safety Module for b maXX 5000 BM5-O-SAF-002/3
Document no.: 5.11016.03
43
of 180
7
7.7.2 Button for verification reasons
The verification of the data import of the controller’s standard parameter data in the Safety
Module’s parameter storage is made with the button on the front side of the Safety
Module, also see chapter
Z
Replacement of the module
–
from page 127).
The S1 button can also be used to acknowledge the message "Encoder fail" (refer to
Z
Acknowledgment encoder fail status
–
on page 40).
Figure 11: Button S1 Safety Module
Off Flashing
(50 ms on /
50 ms off) The configuration file was not loaded, Standard
configuration active (see
Z
Standard Configuration
–
from
page 113)
Flashing Off Device error or unpermitted module change
(commissioning not possible, see
Z
Troubleshooting and
Error Correction
–
from page 137).
On Off Firmware- or parameter data of Safety Module are not
coinciding with the controller’s data. Parameter data of the
controller must be copied to the Safety Module by pressing
the button. The green LED flashes when the button is
pushed.
LEDs