Baker Hughes Panametrics PanaFlow LC, User Manual

Page: 48 / 146

3.5.3d Setting up alarm output
To program an Alarm Output, use steps as in section “Log-in and Primary Pages” to navigate to the Input/Output settings
page:
1. In Meter Menu highlight [Digital Output (Std)] and press [ENTER]. Then select [Alarm] option.
2. Select the [Alarm State], [Alarm type], [Measurement] and [Alarm Value] options to suit your needs. The Figure 60 below,
shows the available options. Also refer to the Table 13 below to understand each option.
For measurement options available on Alarm Output refer to Table 12.
Table 12: Measurement options for Alarm output
Measurement Channel Measurement Options for Frequency Output
Composite
Velocity, Actual Volumetric, Standard Volumetric, Mass Flow,
Average Volumetric Flow Rate, Sound speed, Reynolds #
Channel x
Velocity, Actual Volumetric, Standard Volumetric, Mass
Flow, Average Volumetric Flow rate, Sound speed, Standard
Deviation of Gain, Gain and SNR
Table 13: Alarm Output Options
Option Functional Description
Alarm State
Choose if the Alarm State should be Normally Open,
Normally Closed or Failsafe
Alarm Type
For Alarm State selected as Normally Open or Normally
Closed, Alarm Type can be set to High or Low. If set to high,
Alarm will be triggered if the selected Measurement goes
above the programmed Alarm Value
Measurement
Choose the channel and Measurement that is monitored for
Alarm Trigger
Alarm Value Enter measurement value that should be a trigger point
36