Baker Hughes Panametrics PanaFlow LC, User Manual

Page: 133 / 146

Table 40: Configurable through FF
Calibration
Meter Factor
Calibration Mode Selection
K-Table Selection
Number of Points
Calibration Type Selection
Calibration table
Velocity points (1 to 6)
Reynolds points (1 to 6)
K-Factors points (1 to 6)
H.8 Channel transducer block
The CH1, CH2 and CH3 transducer blocks show the measurement values and programmable parameters for each of the
three paths. Figure 137 below shows the Channel Transducer Block, and Table 41 on page 159 lists the measurements and
parameters that are available.
Note: The R/W designation means that the parameter is writable in FF using an Admin password.
Figure 137: Channel transducer block
121