Baker Hughes Panametrics PanaFlow LC, User Manual

Page: 34 / 146

3.3.1c Selecting a channel measurement to display
To select a Channel measurement to display on the Measurement View, do the following steps and refer Figure 51.
1. Press
[

] until the Measurement name on the meter’s Measurement View display is highlighted, then press [ENTER] .
2. In the Display Measurement select [Channel x] , then press [ENTER] .
3. Then, select the measurement you would like to see on the Measurement View and press [ENTER] .
0.000
m/s
Channel 2
Display Measurement
Channel 3
Composite
Ch1/Inv Vol Measure
Channel 1
Velocity
Volumetric (Act)
Channel 1
Volumetric (Std)
Raw Velocity
Velocity
m/s
m/s
0.000
0.000
Mass Flow
Avg Vol Flow Rate
Batch Vol Total
Channel 1
Inventory Vol Total
Batch Mass Total
Soundspeed
Inventory MassTotal
Gain
Channel 1
Gain
Std Deviation Gain
K-Factor
Diagnostics
Fwd Vol Inventory
Rev Vol Inventory
Net Vol Inventory
Inventory Time
or
or
(or)
Ch 1 Velocity
Ch 1 Velocity
Channel 1
Ch 1/Diagnostics
Transit Time Up
Delta-T
Transit Time Dn
Ch 1/Diagnostics
Sig Quality Dn
Sig Quality Up
Amplitude Up
Amplitude Dn
SNR Up
Ch 1/Diagnostics
SNR Dn
Gain Up
Gain Dn
Error Status
Ch 1/Diagnostics
ATw Amplitude Up
ATw Amplitude Dn
ATw SNR Up
ATw SNR Dn
or
Ch 1/Diagnostics
Wedge Soundspeed
Wall Time
Lining Time
Angle in Fluid
Ch 1/Diagnostics
ATw Gain Up
Wedge Soundspeed
ATw Gain Dn
Wall Time
Figure 51: Selecting a channel measurement to display
22