3. STATUS
3.6
DHCP Status
Information about the DHCP server activity is accessible via
DHCP
item. The DHCP server
provides automatic configuration of the client devices connected to the router. The DHCP
server assigns each device an IP address, subnet mask, default gateway (IP address of router)
and DNS server (IP address of router). DHCPv6 server is supported.
Figure 6: DHCP Status
The DHCP status may occasionally display two records for one IP address. This may be
caused by resetting the client network interface.
Records in the
DHCP Status
window are divided into separate parts according to LAN and
WLAN interface and IPv4 (DHCP) and IPv6 (DHCPv6) – there are parts
Active DHCP Leases
(LAN)
,
Active DHCPv6 Leases (LAN)
,
Active DHCP Leases (WLAN)
and
Active DHCPv6
Leases (WLAN)
if the router has WiFi and WLAN network interface is enabled. In Figure
above there are DHCPv6 server (IPv6) on Secondary LAN interface and DHCP (IPv4) server
on WLAN interface enabled. The table below explains some information from the client list:
18
Summary of Contents for SmartMotion
