4. CONFIGURATION
from the primary and secondary DNS server of the mobile network carrier. To specify the IP
addresses of the Primary DNS servers manually, from the
DNS Server
pull down list, select
the value
set manually
. You can fill-in the IPv4 or IPv6 address of the DNS server (or both)
based on the IP Mode option.
4.4.3
Check Connection to Mobile Network Configuration
If the
Check Connection
item is set to
enabled
or
e bind
, it activates checking
the connection to the mobile network. The router will automatically send ping requests to
the specified domain or IP address (
Ping IP Address
or
Ping IPv6 Address
item) at regular
time intervals (
Ping Interval
). In case of unsuccessful ping, a new one will be sent after ten
seconds. If it fails to ping the IP address three times in a row, the router terminates the current
connection and tries to establish new ones. Checking can be set separate for two SIM cards.
Send an IMCP (ICMPv6) ping to an IP address that you know is still functional. (The operator’s
DNS server, for example.)
If the
Check Connection
item is set to the
enabled
option, ping requests are sent on the
basis of routing table. Thus, the requests may be sent through any available interface. If you
require each ping request to be sent through the network interface, which was created when
establishing a connection to the mobile operator, it is necessary to set the
Check Connection
item to
e bind
. The
disabled
option deactivates checking the connection to the mobile
network.
Enabling the
Check Connection
function for mobile networks is necessary for uninter-
rupted and lasting operation of the router.
Item
Description
Ping IP Address
Specifies the ping queries destination IPv4 address or domain
name. Available in IPv4 and IPv4/IPv6
IP Mode
.
Ping IPv6 Address
Specifies the ping queries destination IPv6 address or domain
name. Available in IPv6 and IPv4/IPv6
IP Mode
.
Ping Interval
Specifies the time intervals between the outgoing pings.
Ping Timeout
Time in seconds to wait for a response to the Ping.
Table 22: Check Connection to Mobile Network Configuration
If you mark the
Enable Traffic Monitoring
checkbox, then the router stops sending ping
request to the
Ping IP Address
(
Ping IPv6 Address
) and it monitors the data stream on the
connection to mobile network. If this connection is without data longer than the
Ping Interval
,
then the router sends a ping request to the
Ping IP Address
(
Ping IPv6 Address
).
37
Summary of Contents for SmartMotion
