B+B SMARTWORK SmartMotion, Configuration Manual

Page: 56 / 144

4. CONFIGURATION
4.6 PPPoE Configuration
PPPoE (Point-to-Point over Ethernet) is a network protocol which encapsulates PPPoE
frames into Ethernet frames. The router uses the PPPoE client to connect to devices support-
ing a PPPoE bridge or server. The bridge or server is typically an ADSL router.
To open the PPPoE Configuration page, select the PPPoE menu item. If you mark the
Create PPPoE connection
check box, then the router attempts to establish a PPPoE connec-
tion after boot up. After connecting, the router obtains the IP address of the device to which
it is connected. The communications from a device behind the PPPoE server is forwarded to
the router.
Figure 30: PPPoE Configuration
Item Description
Username Username for secure access to PPPoE
Password Password for secure access to PPPoE
Authentication Authentication protocol in GSM network
•
PAP or CHAP – The router selects the authentication method.
•
PAP – The router uses the PAP authentication method.
• CHAP – The router uses the CHAP authentication method.
IP Mode Specifies the version of IP protocol:
• IPv4 – IPv4 protocol is used only (default).
•
IPv6 – IPv6 protocol is used only.
•
IPv4/IPv6
– IPv4 and IPv6 dual stack is enabled.
Continued on next page
46