Avid Technology EXPANSION CHASSIS, Instructions For Installing And Using, Page: 57 / 98

I n s t a l l i n g a n d U s i n g t h e A v i d E x p a n s i o n C h a s s i s C h a p t e r 3 • E m p t y C h a s s i s I n s t a l l a t i o n 4 5
4. Reinstall the PCB clamp. Make sure that the fingers on the PCB clamp align
with the slots in the chassis back panel and lock the NuBus cards in place.
Figure 33: PCB Clamp Location
Replacing the Expansion Chassis and Macintosh Covers
To complete the Expansion Chassis installation:
1. Install the Expansion Chassis cover. Make sure that the offset tabs (on the back
of the cover) slide under the rear top flange and lay flat.
2. Push the cover toward the rear of the chassis. Use two screws to fasten the cover
to the chassis.
3. Replace the cover on the Macintosh.
Solving Problems
If you have any problems with the installation of the Expansion Chassis, see the
troubleshooting information in Chapter 6, “Chassis Troubleshooting.”
If you are unable to solve any problems that you have installing the Expansion
Chassis, contact Avid Customer Service for additional help.
PCB clamp
Clamp fingers
NuBus card