Wallboard Installation & Maintenance
Ferrograph Wallboard 10 - Page 59
Serial Connection and Configuration
An RJ45 junction box is provided as standard, alternatively if required an RJ45 coupler
and 2 way adapter can be used. The serial cable is normally connected to the logic
board for RS485 operation, check label on rear of display for specific configuration.
The serial communications lead from the PC is connected to the junction box as shown
later in this manual. Modifications to the network numbers and baud rates can be done
by following the sections below, but changing the dip-switch settings as per the
diagram below.
1. RS232 Connection
2. RS485 Connection 3.
Dip-Switches
To set the network number requires access to the Wallboard 10 logic board as
explained above.
To address individual displays in a network, a network number can be set on the dip-
switch on the logic board. Network 0 is a general address and will accept all data from
the host system. The network number is set using switches 1,2,3 and 4.
Dip-switch Number
1 2 3 4 Network
OFF OFF OFF OFF
0
ON OFF OFF OFF
1
OFF ON OFF OFF
2
ON ON OFF OFF
3
OFF OFF ON OFF
4
ON OFF ON OFF
5
OFF ON ON OFF
6
ON ON ON OFF
7
OFF OFF OFF ON
8
ON OFF OFF ON
9
ETC….
Compact Contact Center Installation Manual
Ferrograph Wallboard 10 - Page 59
40DHB0002USBG Issue 4a (05/29/2003)
Wallboard Installation & Maintenance
