AudioCodes 310HD, Administrator'S Manual

Page: 235 / 284

Administrator's Manual A. Server-Specific Configuration
39 Testing Phone Hardware
The 310HD, 320HD and 420HD IP Phones Built-in Tests (BITs) are described below.
39.1 310HD IP Phone BIT
The 310HD IP Phone provides a built-in test for verifying its operational integrity. These
tests can be performed before deployment and in cases of troubleshooting. These tests are
all performed in one continuous sequence, where each test is followed by another
consecutively, in the order listed below:
„ Keypad and off-hook/on-hook test
„
LED test
„
Handset microphone (recording/speaking) and handset receiver (playing/listening) test
„
Headset microphone (recording/speaking) and headset headphone/receiver
(playing/listening) test
„
Speaker microphone (recording/speaking) and speaker receiver (playing/listening) test
„
MAC address and serial number verification
39.1.1 Test Preparation
Before you can start the built-in test, you need to cable the phone as follows:
1. Connect the phone’s LAN port to a switch, using a LAN cable.
2. Ensure that the DHCP server is functioning.
3. Connect a headset to the phone.
4. Power on the phone and wait until initialization is complete.
5. From this stage onwards, follow the procedures described in the subsequent sections
and in consecutive order. In other words, continue with the procedure described in
Section
39.1.2 on page 236 .
Version 2.0.0 235 October 2012
http://arttel.ru