10
Front and Rear Panels
Figure 2.6: Option 15A Power Supply Ter-
minal Strip Connector
•
Option 15B, 250 Vdc Terminal Power Strip with Surge Withstand Protect Circuitry (SWC)
Figure 2.7: Option 15B Power Supply Ter-
minal Strip Connector
2.3.2
Antenna Input
The Model 1088A/B provides a type-F, GPS antenna input connector not only as the connection
point for GPS signal, but also supplies 5 volts to energize the antenna. It is equipped with a
threaded, type-F female connector.
Shown below is a diagram of the antenna connector. To check for this signal, use a small multimeter
and probe from the center pin of the connector to the threads. Voltage range is 4.9 to 5.1 Vdc. For
further information, see Chapter 4, Antenna and Cable Information.
Figure 2.8: GPS Antenna Connector
2.3.3
Event Input
For timing external events based on the GPS-synchronized time, use the Event Input function with
two separate connectors: J3 Event B input (Standard I/O) and J4 Event A input (Standard I/O).
See Figure 5.1, which illustrates the location of these connectors and jumpers.
2.3.4
RS-232 Communication Ports
The Model 1088A/B has one standard and one optional communication port. Generally, for RS-
232 communications, you will only need pins 2, 3 and 5 using a null-modem cable. For more
information, see Chapter 9, Serial Communications and Command Set.
Summary of Contents for 1088A
