Ametek IPS-4-UV, User Manual

Page: 47 / 200

Installation & Start-Up | 3-17
3. Route the AC power conductors through the Power cable entry port
and into the Electronics Enclosure.
Terminate the AC power wires at TB1 as detailed in the Customer
Connections drawing.
Do not apply power to the system until after all of the wiring has been
installed, connected, and verified, and only if the purging system (if
used) is ready for operation.
4. Plug all unused cable entry ports with certified plugs.
Permanent Ethernet Cable Connections (Optional)
When using the Ethernet interface on the analyzer, the minimum re-
quirements for the Ethernet cable is a CAT 5e (maximum 100 m) cable to
connect the analyzer to the network, up to a maximum of 100 m from
the hub. For outdoor analyzer installations, hazardous locations, and/or
lengths greater than 100 m, special requirements may be necessary. Con-
tact your network administrator for information.
For systems using a permanent Ethernet connection , a ferrite core
(Part Number 301-1044, supplied by AMETEK) must be installed
on the Ethernet cable (supplied by customer), inside the Electronics
Enclosure.
For details about setting up Ethernet parameters, refer to “Ethernet Net-
work Screen” in Chapter 4.
To install the customer Ethernet cable and ferrite core:
1. Route the Ethernet cable through one of the Signal cable entry ports
and into the Electronics Enclosure. Pull through enough cable to loop
around the ferrite.
2. Insert the Ethernet cable through the ferrite core and loop the cable
once around the ferrite, leaving enough cable length to reach the Eth-
ernet port at J18 on the Customer Connection board. Adjust the cable
and ferrite so the ferrite is as close as possible to the Customer Con-
nection board.
Connect the cable to J18 .
3. Route the cable to the network connection in the plant and connect it.
!
WARNING

NOTE