Ametek IPS-4-UV, User Manual

Page: 88 / 200

4-22 | IPS-4-UV Analyzer-GPDiv2
3. From the SETUP menu, select the Calibration Control sub-menu and
press enter. Scroll down to the Calibration Fluid Concentration sub-
menu and press enter to display the Calibration Fluid Concentration
screen (Figure 4-16).
Ensure that the concentration value for the Analyte being spanned
corresponds with the concentration of the span fluid. If not, edit the
value as described under “Calibration Fluids Screen,” later in this sec-
tion.
4. For applications using multiple span fluids:
From the Calibration screen (Figure 4-17b), choose Select Span Fluid
and press
ENTER
to go into Edit mode. Use the
UP
/
DOWN
arrow key
to select the fluid you wish to span and then press
ENTER
to select the
span fluid.
5. From the Calibration screen, select Start span calibration and press
ENTER
to start the span. The analyzer will span the selected fluid and
then return to normal operation ( Measure mode).
6. Turn off the Span fluid.
The span process is complete and the analyzer is now on-line.
7. For applications using multiple span fluids:
Repeat Steps 2 through 6 for each span fluid.
8. Press the
HOME
soft key to return to the HOME screen.
Relay Setup Screens
The Relay Setup screens (Figure 4-18a and 4-18b) allow the user to view or
set up the parameters for up to eight relays. For example, Concentration
Alarms can be set up from this screen ( Relay Function option).
Figure 4-18a.
Relay Setup screen.
 Relays
Relay 1
Relay 2
Relay 3
Relay 4
Relay 5

HOME ALARMS STATUS SETUP
Figure 4-18b.
Relay Setup screen
(Relay 1).
 Relay 1
 Function Disable
Source None
Value 0
Delay 0 Sec
HOME ALARMS STATUS SETUP