Ametek IPS-4-UV, User Manual

Page: 198 / 200

G-2 | IPS-4-UV Analyzer-GPDiv2
118 23 Aspirator pressure high limit
alarm
Alarm Aspirator pressure (345) is higher
than high limit (372)
118 24 Aspirator pressure low limit
alarm
Alarm Aspirator pressure (345) is lower
than low limit (373)
118 25 Internal error Alarm Hardware and/or software errors that
are internal to the system
118 26 Analog board not present Alarm Communication failure to the analog
board
118 27 Discrete board not present Alarm Communication failure to the discrete
board
118 28 Discrete board firmware not
compatible
Alarm Old discrete boards installed in
newer units
118 29 Display board firmware not
compatible
Alarm Old display boards installed in newer
units
118 30 File system error Alarm File system is fragmented; flash chip
is faulty; Unable to read/write to file
system
118 31 Span calibration is required Warning Detected when span calibration was
never performed prior
118 32 Zero calibration is required Warning Detected when zero calibration was
never performed prior
119 1 Zero calibration failure Warning Unable to perform zero calibration
119 2 Span 1 calibration failure Warning Unable to perform span calibration
for analyte 1
119 3 Span 2 calibration failure Warning Unable to perform zero calibration for
analyte 2
119 4 Span 3 calibration failure Warning Unable to perform zero calibration for
analyte 3
119 5 Span 4 calibration failure Warning Unable to perform zero calibration for
analyte 4
119 6 Span 5 calibration failure Warning Unable to perform zero calibration for
analyte 5
119 7 Span 6 calibration failure Warning Unable to perform zero calibration for
analyte 6
119 8 Span 7 calibration failure Warning Unable to perform zero calibration for
analyte 7
119 9 Span 8 calibration failure Warning Unable to perform zero calibration for
analyte 8
119 10 Dark read failure Warning Dark pixel readings are not within a
range of pre-defined values
11 Battery failure Warning System battery fails
119 12 Non-volatile memory
checksum failure
Warning Non-volatile memory, where system
configuration is stored, does not
return correct checksum value
119 13 119 Warning Zero drift has exceeded a pre-
defined allowable value
119 14 Zero average intensity failure Warning Zero average readings of the
intensity of the diod array are out of
specification
119 15 Electronic check failure Warning Verification of the electronic bench
fails
119 16 Verification operation failure Warning Fail to check verification filter
119 17 Sample temperature high limit
alarm
Alarm Heater temperature (292) is outside
of a band set by parameter 287
around the setpoint (293)
119 18 Sample Temp low limit alarm Alarm