Ametek IPS-4-UV, User Manual

Page: 92 / 200

4-26 | IPS-4-UV Analyzer-GPDiv2
Type
This allows you to select the output value range, either 4–20 mA DC
or 0–20 mA DC for the output. Select ‘ 0 ’ for 4–20 mA DC or ‘ 1 ’ for 0–20
mA DC.
Over Range
When enabled, output readings of 3.8 and 20.5 mA will occur if the
analyzer exceeds 4-20 mA.
To change the settings for a current output:
1. Enter a password to allow changes to be made to the current output
settings.
2. Select one of the Current Output ( 1–4 ) sub-menus. Press
ENTER
to
view the Current Output screen.
3. Select the required parameter ( Source, Full, Zero, Type, or Over Range ),
change the settings, and press
ENTER
.
Repeat this step for each parameter and each output.
When entering a value for the Full and Zero parameters:
• Use the
UP
/
DOWN
arrow key to increase/decrease the value in
increments of one (1.00). This works best for minor changes. The
range is 0–100. The current zero-scale set point is displayed on the
right side of the screen.
• If a value exists, use the
LEFT
arrow key as a backspace to erase the
characters to the left of the cursor ( ‘ _ ’ ) if applicable, then use the
numeric keys to enter the new value. This works best for drastic
changes.
Setpoints
The Setpoints screens (Figure 4-20 thru 4-23) allow you to view config-
ured normal operating (factory set) parameters for span, pressure, and
temperature low/high limits.
Figure 4-20.
Setpoints Screen.
Setpoints
> Span Limits
Pressure
Limits
Temperature Limits


HOME ALARMS STATUS SETUP