Ametek IPS-4-UV, User Manual

Page: 199 / 200

Supplemental Information
|
G-3
119 19 Vent temperature high limit
alarm
Alarm Bench temperature (283) is outside
of a band set by parameter 278
around the setpoint (284)
119 20 Vent temperature low limit
alarm
Alarm
119 21-
32
Not used
120 Not used
121 Not used
122 Not used
123 Not used
The bit map of System Warning (parameter 514, 515, 516; 32-bit integer, modbus
register 1034, 1035, 1036, 1037, 1038, 1039) contains warnings as defined:
Modbus
register Bit Description Type Condition
103 4 1-
30
Not used
1034 31 Span calibration is required Warning Detected when span calibration was
never performed prior
1034 32 Zero calibration is required Warning Detected when zero calibration was
never performed prior
1035 1 Zero calibration failure Warning Unable to perform zero calibration
1035 2 Span 1 calibration failure Warning Unable to perform span calibration for
analyte 1
1035 3 Span 2 calibration failure Warning Unable to perform zero calibration for
analyte 2
1035 4 Span 3 calibration failure Warning Unable to perform zero calibration for
analyte 3
1035 5 Span 4 calibration failure Warning Unable to perform zero calibration for
analyte 4
1035 6 Span 5 calibration failure Warning Unable to perform zero calibration for
analyte 5
1035 7 Span 6 calibration failure Warning Unable to perform zero calibration for
analyte 6
1035 8 Span 7 calibration failure Warning Unable to perform zero calibration for
analyte 7
1035 9 Span 8 calibration failure Warning Unable to perform zero calibration for
analyte 8
1035 10 Dark read failure Warning Dark pixel readings are not within a
range of pre-defined values
1035 11 Battery failure Warning System battery fails
1035 12 Non-volatile memory
checksum failure
Warning Non-volatile memory, where system
configuration is stored, does not return
correct checksum value
1035 13 Zero drift exceeded Warning Zero drift has exceeded a pre-defined
allowable value
1035 14 Zero average intensity
failure Warning Zero average readings of the intensity
of the diode array are out of
specification
1035 15 Electronic check failure Warning Verification of the electronic bench fails
1035 16 Verification operation failure Warning Fail to check verification filter