Ametek IPS-4-UV, User Manual

Page: 98 / 200

4-32 | IPS-4-UV Analyzer-GPDiv2
Locking the Password
Use the Lock function to disable the password from the current session.
This reverts all analyzer functions to read-only. Changes to the analyzer
settings cannot be made until the password is entered again.
To lock out all users:
Select Lock and press
ENTER
. The message “ System Locked ” appears. A
padlock icon appears on the top-right side of the HOME screen to indi-
cate the system is currently locked from making any changes.
Removing the Password
To remove password protection:
1. Select Enter Password and press
ENTER
. Key in the password and
press
ENTER
. The software will now allow you to remove the password.
2. Select Change Password and press
ENTER
. Leave the password blank
and press
ENTER
again. The password is removed.
Backup/Restore Settings Screen
The Backup/Restore screen (Figure 4-32) allows you to back up the cur-
rent analyzer configuration settings, restore previously saved analyzer
configuration settings, or restore analyzer configuration parameters to
their original factory-shipped settings.
If major changes are made to the analyzer configuration settings, it is
important to make a backup copy of these settings. This file can then
be used to restore all parameters to their most recently used settings
or the factory-default settings in the event of a serious internal system
error.

NOTE
Figure 4-32.
Backup/Restore
Settings screen.
 Backup settings
Restore settings
Restore factory settings
HOME ALARMS STATUS SETUP