Ametek IPS-4-UV, User Manual

Page: 93 / 200

Controller / User Interface | 4-27
Figure 4-21.
Span Limits
Setpoints Screen.
Span Limits

Span Limit Low 1 0.90
Span Limit High 1
1.10


HOME ALARMS STATUS SETUP
Figure 4-22.
Pressure Limits
Setpoints Screen.
Pressure Limits

Cell Pres High Limit 0 PSI
Cell Pres Low Limit 0 PSI
Pres X 2 High Limit 0 PSI

Pres X 2 Low Limit 0 PSI

Manifold Pres High Limit 0 PSI



HOME ALARMS STATUS SETUP
Figure 4-23.
Temperature Limits
Setpoints Screen.
Temperature Limits

Bench Deviation Limit 0
º
C
Bench Set Point 50 º C
Heater Deviation Limit 0
º
C
Heater Set Point 190 º C
Lamp Deviation Limit 0
º
C


HOME ALARMS STATUS SETUP
Span Limits
If Span limits are exceeded, calibration is required.
Pressure Limits
If pressure limits are exceeded, the system alarm will activate and the ana-
lyzer will go into “Not Ready” state. Limits are disabled if set to 0.
Temperature Limits
If temperature limits are exceeded, the system alarm will activate and the
analyzer will go into “Not Ready” state.
Heater set point should not exceed 190º.
Cell set point should not exceed 150º.
!
CAUTION