Ametek IPS-4-UV, User Manual

Page: 147 / 200

Web Interface | 7-3
Web Interface Components
The Web Interface is divided into six sections. Navigation buttons lo-
cated on the left-hand side of the screen are used to view analyzer sta-
tus, alarms, trends, and spectra; view and change analyzer settings; and
transfer data.
The information displayed on the right-hand side varies depending on
the selected section.
• The web interface header displays the “state” of the analyzer and the
concentration of the analytes being measured. This section is read
only.
- Examples of “states” include Zero, Span, and Measure. These and
other states are described in detail under “System Status Messages
(HOME Screen),” in Chapter 4.
- Analytes are factory set. Up to six analytes can be displayed.
• Alarm and warning notifications are displayed in the banner located
below the header on every screen. The most current notification is
displayed with 1 of x if there are multiple active notifications.
Working From the Web Interface – Conditions and
Messages
While working from the Web Interface, the following condition applies:
The Web Interface is shipped from the factory without password pro-
tection. All configurable parameters can be changed through the web
interface.
Trend and Spectral data are stored in temporary memory. For se-
curity reasons, temporary data can not be stored directly onto the
computer hard drives. Any intentional or unintentional recycling of
power will cause a loss of saved data.
Data cannot be saved directly to your computer. To make a record of
diplayed information use your PC screen capture function and paste
the image into another program.

NOTE