![background image](http://html.mh-extra.com/html/amano/cp-3000/cp-3000_user-manual_2918126060.webp)
6-4
CP-3000 User’s Guide
Printer or printer carriage is damaged. Contact your local Amano
dealer.
A non-Amano ribbon was used. Always use Amano approved
ribbons: non-Amano ribbons bind in the printer carriage, produce
weak quality prints and ink residue on print head, rollers, and
time card.
The slider on the printer carriage is not moving correctly due to a
missing black plastic bushing in the small hole of the right printer
frame. Contact your local Amano dealer.
The card throat width is set too narrow for the card type used.
The card throat must be set to 0.0197” (0.5 mm) greater than the
card width.
The time card you are using is too narrow for the imprint.
Remove characters from the imprint or use a wider card.
There is dirt, oil, dust, or ink residue on the surface of the time
card or the time card surface is too rough for the time card
sensor to detect the
Column Position Block
. Replace the card.
The background color of the time card is too dark.
Time Card Error
When this message is displayed, printing will stop immediately.
Possible reasons for this error can be:
The time card was pushed or pulled when fed into the card throat
or during the printing cycle.
The time card feed mechanism or time card sensors are
damaged.
Imprint/Card Size
This message is displayed when the time card setting has been changed
in
Program Mode
. You must perform a Reset (Clear All) to reset to the
default card type.
Summary of Contents for CP-3000
