- 51 -
Cover L Assy. (Continued)
JJ10510
(E-RETAINING RING 2.5)
RB70042
(MAGNET HOLDER L UNIT)
Confirm that the E-retaining rings are firmly fit.
SLIDE GUIDE
1. Position the Sensor Rod so that its two slots will be projected from the Slide Guide, and set the
E-Retaining Ring
.
2. Put the slotted end of the Sensor Rod into the Magnet Holder L Unit, in the direction shown in the
figure.
3. Set the E-Retaining Ring
.
4. Push the Compression Spring in between the Slide Guide and the remaining slots of the Sensor Rod
via the Plain Washer and set the E-Retaining Ring
.
Note) Confirm that the Magnet Holder L Unit is marked with "L".
Confirm that the E-Retaining Rings are firmly fit into the slots in the Sensor Rod.
Confirm that the Sensor Rod and the Magnet Holder L Unit are activated interlockingly by a
spring force.
ASSEMBLY PROCEDURE
