- 22 -
Main Switch Base Assy. (Continued)
1. Position a Torque Dial to the position “2” as shown in the figure.
2. Position the concave part of a Rotary Switch shaft to "1".
Note) Improper positioning of the Torque Dial and Rotary Switch dislocate them from each other.
3. Insert a LED unit connector into a Sub-board Unit.
4. Connect the harness of a Main Switch Unit to the one (red) coming from the Sub-board Unit.
5. Insert the Rotary Switch into a Dial joint and fix the Main Switch Base and Sub-board Unit with a
Tapped Screw 3 x 6.
(Tightening torque: 40-50 cN.m)
6. After assembling, turn the Torque Dial to confirm that it is changed over in 8 steps.
ASSEMBLY PROCEDURE
TORQUE ADHESIVE
40-50 cN.m
Not required
RB70367
BOARD (RB655) UNIT
Plug the connector
of the LED unit.
Position "
<
" of the Torque dial as
shown in the figure.
(Dial position = 2)
Position the
concave part of
the Rotary
switch to "1".
Turn to confirm.
Purple
White
Blue
Yellow
Brown
Black
Red
AA31721
(TAPPED
SCREW 3 x 6)
