- 42 -
Arm B Assy. (Continued)
1. Apply Molykote PG-662 Grease to a Cutter Lever Pin.
2. Put the Cutter Lever Pin through a smaller hole in a Cutter Lever and secure with an E-Retaining
Ring 4.
3. Put the other end of the Cutter Lever Pin through a Cutter Connecting Rod and secure with an
E-Retaining Ring 4.
4. Degrease a Cutter Shaft and apply Molykote PG-662 Grease only to the slideway with a Cutter
Lever.
5. Put the Cutter Shaft through the Cutter Lever and an Arm B Unit.
6. Apply epoxy glue only to the threaded part of the Cutter Shaft and tighten a Hex. nut 1-4.
(Tightening torque: 200-250 cN.m)
7. Place the nut facing downward to dry Epoxy glue.
Note) Make sure that the E-Retaining Ring is firmly fit into a groove in the Cutter Lever Pin.
Ensure that the threaded part of the Cutter Shaft is free of Molykote PG-662 Grease.
Ensure that the Cutter lever is free of Epoxy glue when adhering and drying it.
ASSEMBLY PROCEDURE
TORQUE ADHESIVE
200-250 cN.m
Epoxy glue
CC41103
(HEX NUT 1-4)
JJ10101
(E-RETAINING RING 4)
RB10753
(CUTTER LEVER PIN)
RB10750
(CUTTER CONNECTING ROD)
JJ10101
(E-RETAINING RING 4)
RB10751
(CUTTER LEVER)
Put it through the holes
in the Cutter lever and
Arm B, and then, apply
epoxy glue.
Dry epoxy glue as shown in the figure.
RB10752
(CUTTER SHAFT)
GREASE
MOLYKOTE PG-662
GREASE
MOLYKOTE PG-662
Downward
