- 67 -
Step
1. Connect the 3P of a Harness 11P unit to a Sensor Board E Unit.
2. Connect a Harness 3P Unit to a Sensor Board D Unit.
3. Assemble a Sensor Base Assy. to a Frame L. When this is done, pass the 3P Harness under a
Finger Base through a notch
.
4. Route the yellow, blue, and white harnesses coming from the sub-board, one by one in that order,
between the frame L and the Sub-board, through a notch
, followed by Area B to wire them as
shown in the figure.
5. Route the brown and purple harnesses coming from the sub-board, one by one in that order,
between the frame L and the sub-board, and through the notch
to expose them from the back of
the Frame L as shown in the figure.
6. Route a black harness coming from the Sub-board between the frame L and the sub-board, through
the notch
, followed by Area B to wire it as shown in the figure.
7. Wire a red harness coming from the Main Switch Unit as shown in the figure.
8.
Assemble the electrode block with its notch facing upward. Confirm that the red harness is
on the upper side.
ASSEMBLY PROCEDURE
Notch
Harness (black)
Harness (red)
B-part
Ensure that the harness
is not exposed from the
rib of the frame.
Harness (blue)
Harness (yellow)
Notch in Electrode Block
Notch
Harness (white)
Harness (blown) and (purple)
Notch
Wire the yellow, blue, white, black, brown,
and purple harnesses coming from the sub-
board unit to the frame, one by one in that
order.
Wire a red harness from the main switch as
shown in the figure.
Sensor base assy
RB70086
(HARNESS 3P UNIT)
Sensor
board E unit
Sensor board
D unit
Route the 3P harness under the
projection of the jaw base.
Notch
Notch
Purple
White
Blue
Yellow
Black
Red
Blown