- 37 -
Magazine Assy. (Continued)
Adjust Ring Height Adjustment Process
Direction
1
st
Step
(Loosest)
2
nd
Step
3
rd
Step
4
th
Step
(Tightest)
Counterclockwise
Clockwise
1. Turn the Magazine Stopper until it hits the projection of the Magazine Cover, followed by the Adjust
Ring in the clockwise direction until it also comes to stop.
2. Close the Magazine Cover Assy. Align the Magazine Stopper with “CLOSE” to prevent the Magazine
Cover from being opened.
3. Holding the Magazine Stopper, turn the Adjust Ring in the clockwise direction until you feel a strike.
(1
st
step, the slackest position)
4. Make the Magazine Stopper float by its backlash and turn it in the counterclockwise direction with a
finger tip to stop it at the 3
rd
step.
(Shift from the 1
st
to the 2
nd
and 3
rd
step, while confirming.)
5. Only when it is not easy to turn the Adjust Ring in shifting to the 3
rd
stage, return it in the clockwise
direction, holding the Magazine Stopper, and stop it where the 1
st
tapped screw is aligned (2
nd
step).
6. Tighten tapped screws 2.6 x 6. (Tightening torque: 15-20 cN.m)
Note) Control torque after confirming that the screws have been fully seated.
ASSEMBLY PROCEDURE
TORQUE ADHESIVE
15-20 cN.m
Not required
RB10806
(ADJUST RING)
RB11774
(MAGAZINE
STOPPER)
Turning
Direction for
Projection
Turning
Direction for
Turning
Direction for
AA32708
(TAPPED SCREW 2.6 X 6)
Only when hard to
shift to the 3
rd
step
Adjust at the 3
rd
or 2
nd
step.
(Not at 1
st
or 4
th
step)
