- 68 -
Step
GREASE
MOLYKOTE PG-662
Wire Guide Lever
Cutter Ring
Notch
Sensor Board A Unit
Sleeve Guide
Sensor Board G Unit
Sensor Base Assy
Internal
Gear B
RB70056
(MOTOR GEAR B UNIT)
Arm Shaft
Guide
3P(Sensor Board E Unit)
Pawl Base
GREASE
MOLYKOTE PG-662
Putting Harness 11P
Unit through
After inserting into the connector, put the
harness through the notch of the arm shaft guide.
Notch of Arm
Shaft Guide
Confirm that the cutter
ring is properly fit onto
the wire guide lever.
Harness 3P unit
Apply Molykote PG-662 to the
contact surface of the cutter
lever and the cutter ring.