- 71 -
1. Connect the three harnesses of the twisting motor TD5046 unit to the terminals of the Sub-board in
order of yellow, blue and white.
2. Insert the Motor Shaft into a hexagonal hole in the Motor Gear B. (With the Motor Assy. tilted as
shown in the figure)
When this is done, pass the Motor Housing Sssy. under the harness (red) of the main switch.
After inserting the Motor Shaft, confirm that the Motor Assy. is properly fit into the Frame L.
3. Pass the Fan Unit connector under the harness (red) of the Main Switch to connect it to the Fan
connecting terminal of the Sub-board.
4. Pass the Motor Sensor Connector under the harness (red) of the Main Switch to connect it to the
Motor Sensor Connecting Terminal of the Sub-Board
5. Lay out the motor terminals in the grip as shown in the figure.
6. Lay out the harness (red) of the Main Switch in the wiring grooves in the Motor Housing R as shown
in the figure.
ASSEMBLY PROCEDURE