- 49 -
ADJUSTMENT OF WIRE GUIDE UNIT
STEP 1 Unscrew the set screw 3x3 (AA71408), then slide the Wire Guide Lever and set the Wire Guide Unit
in its open position. Put Loctite Blue on the set screw 3x3 and tighten it again.
STEP 2 Connect an object which weighs
9 to 10 oz
(Ex. Twisting Motor) to Wire Guide Lever with tie wire
and lift the Arm. Then unscrew the set screw 3x3 (AA71408) slowly until the Twister Assy falls.
Be sure to
stop unscrewing when the Twister Assy falls.
STEP 3 Assemble the Wire Guide Lever and confirm that the Lever moves smoothly.
Also make the Wire guide unit in its closed position and confirm that the gap between silver pin of Wire Guide
Unit and Arm A is less than 0.8mm which is diameter of TW897 wire.
(If the TW897 wire does not pass through the clearance, it means the adjustment is correctly done.)
Slide the Wire Guide Lever
and set the Wire Guide Unit
in its open position.
Unscrew the set screw.
Apply Loctite and tighten
the set screw again.
