![background image](http://html1.mh-extra.com/html/airmatic/rb655/rb655_service-manual_2878472014.webp)
Must Do Maintenance
before the tool reaches 500,000 tie
s
RB10749
CUTTER
The edge of the Cutter is worn out, the cutting load becomes higher then
the tool can not to cut the wire. (The overcurrent beep sound may be
heard when cutting load is too high and the cutting action is prevented.)
At around 200,000 ties, replace the Cutter
with a new one.
It is recommeded to replace Feeding Motor
at the same time.
RB10748
FIXED CUTTER
The edge of the Cutter is worn out, the cutting load becomes higher then
the tool can not to cut the wire. (The overcurrent beep sound may be
heard when cutting load is too high and the cutting action is prevented.)
When replacing the Cutter (RB10749) at
around 200,000 ties, reverse the direction
of the Fixed Cutter.
Also clean up the Cutters and apply small
amount of the Molykote grease.
At around 500,000 ties the Fixed Cutter
should be replaced with a new one.
-
Maintenance of the area
around the HOOKS
The dust/metal powder around the Hooks makes movement of the Hooks
not smooth, and the load on the Twisting Motor to open and close the
Hooks becomes higher. It the load becomes too high, the wire cannot be
cut. (The overcurrent beep sound may be heard when cutting load is too
high and the cutting action is prevented.)
At around 200,000 ties, clean the Hooks
with degreaser like Paslode Degreaser
Cleaner then apply Molykote grease.
RB70351
FEEDING MOTOR
The tool can not feed the wire because the brush of the Feeding Motor is
worn out. At initializing action, feeding error beep sound may be heard.
(The Twisting Motor is brushless motor and does not have wearing part.)
At around 200,000 ties, replace the
Feeding Motor with a new one.
It is recommeded to replace Cutter at the
same time.
-
The maintenance for FEEDING
MOTOR
Due to the dust on Feeding Gears, the feed sensor may not sence all of
the magnets around the gear then the tool may feed more wire than
required.
When replacing the Feeding Motor with a
new one. Open the Motor Cover of the
Feeding Motor and clean up the magnets
around the Feeding Gear with compressed
air.
RB11762
HOOK L
RB11763
HOOK R
RB70275
CENTER HOOK
RB81102
MAGAZINE ASSY
RB81103
MAGAZINE COVER ASSY
- 12 -
Part code
Part name
Phenomenon
The recommended maintenance
and its frequency
Inside of the Magazine and Magazine Cover is worn out and hte play
between Magazine and Magazine Cover becomes larger. It leads to too
much friction on wire at wire pulling action and may create weak tie.
At around 500,000 ties, the Magazine and
magazine Cover need to be replaced with
new ones.
When the Hooks are worn out, the space between Center Hook and Hook
becomes wider when the Hooks catch the wire. Due to this, the strength of
cramping wire decreases and the tip of the wire may be released from the
Hooks during the twisting action.
At around 500,000 ties, the Hooks need to
be replaced with new ones.