- 55 -
Cover R Assy. (Continued)
JJ10510
(E-RETAINING RING 2.3)
RB70045
(MAGNET HOLDER R UNIT)
SLIDE GUIDE
1. Position the Sensor Rod so that its two slots will be projected from the Slide Guide, and set the
E-Retaining Ring
.
2. Put the slotted end of the Sensor Rod into the Magnet Holder R unit, in the direction shown in the
figure.
3. Set the E-Retaining Ring
.
4. Push the Plain Washer and Compression Spring in between the Slide Guide and the remaining slots
of the Sensor Rod and set the E-Retaining Ring
.
Note) Confirm that the Magnet Holder R Unit is marked with "R".
Confirm that the E-Retaining Rings are firmly fit into the slots in the Sensor Rod.
Confirm that the Sensor Rod and the Magnet Holder R Unit are activated interlockingly by a
spring force.
ASSEMBLY PROCEDURE