INSTRUCTIONS
FUNCTION AND OPERATION
This tool features a tape measure, a level, 13 screwdriver bits, a miniature hammer, and LED flashlight.
1. THREE POSITION SCREWDRIVER WITH MAGNETIC BIT ATTACHMENT:
• Slide the release button down. The bit attachment will spring out and automatically lock in place. (There are two angle positions to choose).
• Lift the top handle to reveal the bit assortment.
• Select your chosen bit and place into the end of the bit attachment. You are now ready to commence with the job in hand.
• When finished, slide the release button down and at the same time, push down the bit attachment back into place.
2. BITS ASSORTMENT:
Assortment of 13 screwdriver bits in different types and sizes.
3. MINIATURE HAMMER:
Fold the tool when in use.
4. TAPE MEASURE:
Pull out the free end to the desired length. Release free end to allow the tape measure to fold away into the tool.
5. LEVEL:
Place the folded tool onto the surface you require to level. When the bubble sits neatly in the center of the window,
between the two black lines, your item is level and can be fixed in place.
6. LED FLASHLIGHT:
Use 2 x CR2032 DC 3V button cell battery (Included).
Press ON/OFF switch to turn ON, and press again to turn OFF.
TO REPLACE BATTERY:
1. Lift the top handle, slide open the Battery Lid. Then insert 2 new CR2032 batteries with correct polarities.
2. Close the Battery Lid and top handle.
BATTERY NOTE:
For best results. be sure to check the expiration date because fresh button cell batteries will ensure uninterrupted usage/enjoyment of the
product. Remove the button cell batteries if the product will not be used for an extended period. Correct battery installation, or try a fresh set of cell batteries.
CAUTION:
Batteries should be removed and replaced by adults only. Do not mix old and new·cell batteries. Do not mix alkaline, standard (carbon - zinc), or
rechargeable (nickel-cadmium) Batteries. Do not use rechargeable batteries. To avoid explosion or leakage, do not dispose of batteries in a fire or attempt to
recharge standard or alkaline batteries. Be sure to insert batteries with the correct polarities and always follow battery manufacture’s instructions. Remove
batteries and store them in a cool, dry place when not in use. Be sure to always remove old and dead batteries from product.
Wear Safety Goggles
tools for life
6
5
1
4
3
2
www.kelvintools.com
Patent # US D650,257 S
LED flashlight
Use as worklight or
in an emergency
Light On/Off Switch
Integrated
liquid level
SnapAction Screwdriver
Push the button and it snaps to attention, ready to work.
Lock it at 90˚ for extra torque or fold it closed to save space.
Alloy magnet holds
bits and screws
Scewdriver release button
13 everyday use bits:
4 Phillips, 3 Allen key,
3 Torx & 3 Slotted.
Carbon steel
hammering surface
Convenient
3 foot / 1 meter
measuring tape
Battery Lid
1.
Lift the top handle.
2.
Slide open the
Battery Lid
3.
Place 2 x CR2032 batteries
inside while both batteries
matching the polarity in
the side of the battery
compartment
+
WARNING: THIS PRODUCT IS NOT A TOY. FOR ADULT USE ONLY
1. This product contains 2 small batteries. Swallowed batteries can also cause nerve damage and paralyze the vocal cords.
Seek immediate medical attention if battery(s) are swallowed or inhaled. Keep small batteries out of the reach of children.
2. Small parts are a choking hazard. Keep out of the reach of the children.
+
+
