Agilent Technologies 8360 L Series, Service Manual

Page: 510 / 603

T able 8-1.
Adjustments and P erformance T ests Required
After Repair or Replacement of an Assembly (continued)
Assembly Adjustment P erformance T est
A24Lo w Band Mo dulator Oset and Gain
ALC P ow er Level Accuracy
P ow er Flatness
F ull Self{T est
P ow er Accuracy
P ow er Flatness
Maxim um Leveled P ow er
Spurious Signals (Harmonics)
Spurious Signals
(Non-Harmonics)
Single Sideband Phase Noise
Pulse Mo dulation On/O
Ratio
1
Pulse P erformance
1
Pulse Mo dulation Video
F eedthrough
1
AM Accuracy
1
AM Bandwidth
1
AM Dynamic Range
1
A26 YIG Oscillator YO Driver Gain and Linearity
YO Delay (Automated)
FM Gain
1
F ull Self{T est
Sw ept F requency Accuracy
F requency Switching Time
Maxim um Leveled P ow er
Spurious Signals (Harmonics)
Single Sideband Phase Noise
FM Accuracy
1
FM Bandwidth
1
Maxim um FM Deviation
1
A28 Amp/Mult Amp/Mult Adjustmen ts
Amp/Filt Adjustmen ts
F ull Self{T est
Maxim um Leveled P ow er
Spurious Signals (Harmonics)
FM Bandwidth
1
A29 Amp/Filter Amp/Filter Adjustmen ts F ull Self{T est
Maxim um Leveled P ow er
Spurious Signals (Harmonics)
Pulse P erformance
1
FM Bandwidth
1
A30 Directional Coupler ALC P ow er Level Accuracy
P ow er Flatness
F ull Self{T est
P ow er Accuracy
Maxim um Leveled P ow er
1
This adjustment or p erformance test is required only for the 8360 B-Series sw ept signal
generator. Do not p erform this adjustment or test on the 8360 L-Series sw ept CW generator.
2
The adjustments listed are required only after r ep air of the assembly . The r eplac ement assembly
is adjusted at the factory and is not instrument-dep enden t.
8-4 P ost{Repair Agilent 8360