Agilent Technologies 8360 L Series, Service Manual

Page: 509 / 603

T able 8-1.
Adjustments and P erformance T ests Required
After Repair or Replacement of an Assembly (continued)
Assembly Adjustmen t P erformance T est
A13 YO Driver YO Driver +10 V Reference
YO Driver Gain and Linearity
YO Delay (automated)
F ull Self{T est
Sw ept F requency Accuracy
F requency Switching Time
Single Sideband Phase Noise
Maxim um FM Deviation
1
A14 Sw eep Generator Sw eep Ramp F ull Self{T est
Sw ept F requency Accuracy
A15 CPU Selftest P atches (L Mo dels only)
ADC (automated)
F ull Self{T est
GPIB Self{T est
A16 P ostregulator None F ull Self{T est
A17 Rectier/Filter None F ull Self{T est
A18 Switching Regulator None F ull Self{T est
A19 Rear P anel Interface None F ull Self{T est
GPIB Self{T est
A20 RF Interface None F ull Self{T est
Op eration V erication
A21 Alphan umeric Displa y None F ull Self{T est
GPIB Self{T est
A22 Motherb oard None F ull Self{T est
Op eration V erication
A23 10 MHz Reference
2
10 MHz Standard F ull Self{T est
Internal Timebase: Aging
Rate
Single Sideband Phase Noise
1
This adjustment or p erformance test is required only for the 8360 B-Series sw ept signal
generator. Do not p erform this adjustment or test on the 8360 L-Series sw ept CW generator.
2
The adjustmen ts listed are required only after r ep air of the assembly . The r eplac ement assembly
is adjusted at the factory and is not instrument-dep enden t.
Agilent 8360 P ost{Repair 8-3