Agilent Technologies 8360 L Series, Service Manual

Page: 160 / 603

System Calibration
Note
The pulse generator output lev el can b e aected b y loading. Lea v e the pulse
generator connected to the oscilloscop e's c hannel 2 (through the BNC tee) as
y ou set the output lev el.
4. On the oscilloscop e, set:
Channel 1:
Display On
Volts/Division 50 mV
Offset 0 V
Input Coupling dc
Input Impedance 50
Channel 2:
Display Off
Input Impedance 50
Timebase:
Time/Division 20 ns
Delay 0 s
Delay Reference At center
Trigger:
Trigger Mode Edge
Trigger Source Channel 1
Trigger Level 0.05 V
Trigger Slope Positive
Display:
Display Mode Repetitive
Averaging On
Number of Averages 16
5. On the pulse generator, set:
Pulse: Selected
Pulse width: 10 ns
Frequency: 2 MHz (500 ns)
Offset: 0 V
6. On the pulse generator, set the pulse amplitude for a reading of 0.1 V on the oscilloscop e.
Video Gain
7. Connect the pulse generator to the oscilloscop e's c hannel 1 through the attenuator, lters,
and amplier (B).
8. On the oscilloscop e, set:
Channel 1:
Volts/Division 0.2 V
Offset 00.3 V
Input Coupling dc
Agilent 8360 P erformance T ests
Pulse Modulation Video Feedthrough
2-73