ADS 507165, Installation, Operation And Maintenance Manual

Page: 418 / 535

11-20 ADS Manual
18. Reconnect the sensor cable(s) to the appropriate port(s)
(
Channel 1 and/or Channel 2 ) on the monitor.
Inspecting, Cleaning, and Handling the
Sensors
Perform the following sensor inspections during regular site visits:
z
Verify that the installation ring, bands or Mounting Bar are
secure and clear of debris.
z
Carefully remove any debris that has accumulated on or around
the Long Range Depth Sensor.
z
Clean the face of the Submersion Sensor with a clean, moist
cloth as needed.
z
Clean the face of the Surface Combo Sensor/Ultrasonic Depth
Sensor gently with a soft brush, and wipe the sensor with a
clean, moist cloth.
Note: The crystals on the Surface Combo Sensor are
covered with a Teflon ® coating. Therefore, do not use a
wire brush or other abrasive, metallic device to clean these
sensors.
z
Verify that the face of the ParaDepth or ParaFlow sensor are
level side to side and front to back using
Qstart XML software.
Refer to Chapter 4 , Configuration and Activation for more
information.
z
Verify that the face of the Surface Combo Sensor/Ultrasonic
Depth Sensor is horizontally level with the flow. If necessary,
reposition the sensor according to the procedures in
Chapter 5 ,
Sensor Installation and Connection .
z
Scrub the face of the AV|Gated, AV|Max and/or Peak Combo
sensor with a soft bristle brush.