ADS 507165, Installation, Operation And Maintenance Manual

Page: 14 / 535

1-6 ADS Manual
ADS’ 9000 -0080 antenna is the recommended antenna for use with
the monitor. Customers also may obtain their own
antennas to accommodate specific project needs or requirements.
However, when assessing a third-party antenna, please consult an
ADS representative prior to installing the antenna to verify the
antenna can adequately support monitor communications.
Connecting the to the Telog RTU (Model Ru-33) also
supports wireless communication via the Telog “passthrough”
mode. The Telog is mounted next to the in the
hazardous area and connected to the monitor using the Triton-Telog
Comm Cable (ADS p/n 8000-0054-01).
However, please note that,
because the Telog unit does not possess IS certification, the
installation will not be considered intrinsically safe if the Telog unit
is installed in the manhole with the monitor.
Installation and IS Considerations
When installing the flow monitor, carefully follow any
local regulations for the installation of IS equipment. For example,
many clients only allow the use of special
hazardous area tools
(flashlights, radios, etc.) in manholes. Some clients will not allow
the use of an electric drill, either battery-powered or AC-powered,
in a manhole. In this case, air (i.e., pneumatic) tools must be used.
When in doubt as to the applicable regulations, check with the
client or the client’s designated safety r epresentative.
Specific Conditions of Use
During the ATEX/IECEx/CSA/UKCA approval process, certain
conditions are set forth that must be observed when using the
certified equipment. These
Specific Conditions of Use can be found
in the body of each certification (referenced in this manual), as well
as on a page attached to the Declaration of Conformity. Following
is a summary of these Safe Use Instructions: