ADS 507165, Installation, Operation And Maintenance Manual, Page: 367 / 535

9-4 ADS Manual
Following are some common connection points:
‰ Inside the transmitter that supplies the signal
‰
SCADA I/O termination panel
‰
PLC analog I/O terminals
‰
RTU analog I/O terminals
‰
Strip chart recorder I/O terminals
‰
Integrator/totalizer I/O terminals
‰
Front panel display I/O terminals
2. Configure the Analog Input 1 (or 2) component of the XIO
Device through
Q start
XML
with the analog input
parameters that indicate the values or measurements that
correspond to the analog signals within the 4-20mA range
and the specific kind of data you want the monitor to store.
Refer to
Chapter 4 , Configuration and Activation , for
instructions on supplying this information in Q start XML .
3. Connect the analog input wires to the ADS XIO in the
following way:
Note: Make sure the power is turned off to the third-party
device and XIO.
‰ Release the latches and open the clear, front door on
the XIO.
‰ Run the wires up through the left cable gland on the
XIO into the enclosure. ADS recommends using 18-
gauge wiring. You may need to loosen the plastic nut
on the cable gland on the outside of the XIO to feed
the wires through.